1 To tie Elliott’s rig you will need the following bits and pieces.
2 Start off by removing a 15-inch length of N-Trap hooklink.
3 Remove six-inches of coating, form a Hair loop and attach the bait.
4 Now position a ring three-quarters of an inch above the bait.
5 Position the ring at the bottom of the shank, where it starts to curve.
6 Now whip a Three-Turn Knotless Knot in order to secure it all in place.
7 Pierce a 1cm length of tubing and then pass the needle out the other end.
8 Position it over the hook’s eye so the hooklink exits inline with the point.
9 Use the steam from a kettle to shrink the tubing down so it’s secure.
10 It’s now ready to rock: and as proven in Below The Surface, it’s deadly.